Download  Print this page

Philips FM20/30 Instructions For Use Manual Page 53

Release j.3 with software revision j.3x.xx patient monitoring.
Hide thumbs

Advertisement

User Default
The
User Defaults
store the active settings, modified to your preference, in the
In Monitoring Mode, you can load the
Select the
1
2
Select
Factory Default
The
Factory Defaults
Configuration Mode, you can load the
CAUTION
This resets all settings to factory defined values, but be aware that some values will differ from those
with which the fetal monitor was originally shipped from the factory (recorder speed and paper scale
type will need to be corrected, for instance). After loading the
if necessary, change them to the settings you normally use.
You can use the
Guide for details.
Global Settings
General monitor configuration settings are stored in the
frequency, QRS type, and whether the monitor is automatically reset to the
interruption of more than one minute. You can change the
Changing Measurement Settings
Each measurement has a setup menu in which you can adjust all of its settings. You can enter a setup
menu:
1
with the measurement numeric - select the measurement numeric on the screen to enter its setup
menu. For example, to enter the
with the
2
switched off, use the
name from the pop-up list. With this SmartKey you can access any setup menu in the monitor.
This guide always describes the entry method using the measurement's setup menu. You can use the
method you prefer.
Switching the Noninvasive Blood Pressure Measurement On and
Off
The noninvasive blood pressure measurement can be manually switched on and off. To do this:
1
Enter the noninvasive blood pressure measurement's setup menu.
Select
2
are a complete configuration stored in the monitor's long-term memory. You can
SmartKey
Defaults
in the dialog box to load the
Confirm
is a complete configuration pre-defined at the factory. You cannot modify it. In
as the basis for producing your
Factory Defaults
SmartKey - if you want to setup a measurement when the measurement is
Main Setup
Main Setup
to toggle between
NBP
On
User Defaults
settings to return to your preferred settings:
User Defaults
User Defaults
as the active settings.
Factory Defaults
Global Settings
Global Settings
menu, select the
Setup FHR1
SmartKey and select
Measurements
and
. The screen display indicates the active setting.
Off
3 Basic Operation
(in Configuration Mode).
.
, check the settings, and
Factory Defaults
. See the Configuration
User Defaults
. These include settings for line
User Defaults
in Configuration Mode.
(fetal heart rate 1) numeric.
FHR1
. Then select the measurement
after a power
53

Advertisement

Table of Contents

   Related Manuals for Philips FM20/30

This manual is also suitable for:

Avalon clFm40/50

Comments to this Manuals

Symbols: 0
Latest comments: