Download  Print this page

Philips FM20/30 Instructions For Use Manual Page 50

Release j.3 with software revision j.3x.xx patient monitoring.
Hide thumbs

Advertisement

3 Basic Operation
SmartKey
50
Name
Function
Pages the patient. Only enabled if at least one
Call Patient
CL transducer is currently active
Pauses alarm indicators. Pause duration depends on
Pause Alarms
monitor configuration. If the pause duration is infinite, this
key is labeled
Select again to immediately re-enable alarm indicators
Loads User Default
Defaults
Enters main setup menu
Main Setup
Starts/stops manual noninvasive blood pressure
Strt/Stp NBP
measurement
Starts auto series
Stops current automatic measurement within series
Starts manual noninvasive blood pressure measurement
Start NBP
Starts auto series
Stops manual noninvasive blood pressure measurement
Stop NBP
Stops current automatic measurement within series
Stops all noninvasive blood pressure measurements
Stop All NBP
Sets the time interval between two noninvasive blood
Repeat NBP
pressure measurements
Access NBP mode selection and setup, with direct start/
NBP Modes
stop function
Allows the manual input of the patient's temperature
Enter Temp
Resets the display and trace to 0. If you do not zero the
Zero IUP
monitor properly, the pressure trace may exceed the paper
scaling.
Enters NST timer window
Timer
Enters the Standby mode, suspends monitoring. All
Standby
numerics and waves disappear from the display. All settings
and patient data information are retained
Enters the patient identification menu to admit/discharge
Patient Demogr.
Quick admits the patient for monitoring
QuickAdmit
Blank key, can be used as divider between a group of keys
Blank Key
Alarms Off

Advertisement

Table of Contents

   Related Manuals for Philips FM20/30

This manual is also suitable for:

Avalon clFm40/50

Comments to this Manuals

Symbols: 0
Latest comments: