Download  Print this page

Philips FM20/30 Instructions For Use Manual Page 38

Release j.3 with software revision j.3x.xx patient monitoring.
Hide thumbs

Advertisement

3 Basic Operation
Docking Slot for Cableless Measurement Pods
The Avalon CL base station has one docking slot to hold an IntelliVue CL Pod. The CL Pod is
charged while docked. The LED under the docking slot indicates the battery status of the CL Pod. The
base station has a built-in short range radio interface with an integrated antenna to communicate with
the CL Pod.
WARNING
Short range radio connections are subject to interruption due to interference from other radio sources
in the vicinity, including microwaves, bluetooth devices, WLAN devices (802.11b,g,n), and cordless
phones. Depending on the strength and duration of the interference, the interruption may occur for an
extended period. A loss of connection, due to moving out-of-range, interference, or for other reasons,
is indicated with a
Pods, or a
configuration is important, see the Configuration Guide for details.
Audio Signal CL Base Station
The Avalon CL base station has two audio signals:
If the base station issues a descending tone sequence, the attempt to set up radio communication to a
CL transducer has failed.
The base station issues a permanent beeping tone if it is disconnected from a fetal monitor, or if
the FM20 or FM30 monitor is switched off, and the base station has transducers currently docked
that need to be recharged.
If an interval tone is played, the battery of one or more the CL transducers or CL Pods need to be
recharged.
Alarming is only available at the Avalon Fetal Monitor, not at the Cableless Measurement Devices, see
the Instructions of Use for the IntelliVue Cableless Measurements.
38
No Host Monitoring
or
cl NBP Disconnect
cl SpO Disconnect
1
Docking slot for CL Pods
INOP (here the host is the fetal monitor) on the NBP or SpO
INOP at the fetal monitor. Correct channel
2

Advertisement

Table of Contents

This manual is also suitable for:

Avalon clFm40/50

Comments to this Manuals

Symbols: 0
Latest comments: