Download  Print this page

Philips FM20/30 Instructions For Use Manual Page 148

Release j.3 with software revision j.3x.xx patient monitoring.
Hide thumbs

Advertisement

11 Monitoring FHR and FMP Using Ultrasound
FMP Statistics
FMP statistics are printed every ten minutes.
1
2
A
B
C
The FMP detection activates after about half a minute of steady heart rate signals (signal indicator half-
full, or full) to minimize transducer positioning artifact. You will notice this deliberate delay:
When a new patient is admitted. A patient discharge restarts the FMP statistics from zero.
When you connect an ultrasound transducer.
Switching FMP On and Off
You can switch FMP on and off from any FHR channel. For example, to set it from the FHR1
channel:
Enter the
1
2
Select
Return to the main screen.
3
148
FMP enabled
FMP started here
Indication of current fetal movement.
The FMP statistics are presented as two percentage figures:
The first figure shows the percentage of detected fetal movements in the previous ten
minutes.
The second figure shows the percentage of detected fetal movements since the start of
recording.
To mark the start of the FMP statistic, FMP is printed on the paper with an arrow.
menu.
Setup FHR1
to toggle between
Fetal Movement
and
.
On
Off

Advertisement

Table of Contents

This manual is also suitable for:

Avalon clFm40/50

Comments to this Manuals

Symbols: 0
Latest comments: