17-82 SELF-DIAGNOSIS SYSTEM
Quick Shifter Sensor (Service Code 3E) (DTC P0826)
If the reading is within the standard, remove the ECU and
check the wiring for continuity between main harness con-
Disconnect the ECU and sensor connectors.
Wiring Continuity Inspection
ECU Connector [A] ←→
Quick Shifter Sensor Connector [B]
G/W lead (ECU terminal 46) [C]
G lead (ECU terminal 38) [D]
If the wiring is good, check the ECU for its ground and
power supply (see ECU Power Supply Inspection in the
Fuel System (DFI) chapter).
If the ground and power supply are good, replace the ECU
(see ECU Removal/Installation in the Fuel System (DFI)
Quick Shifter Sensor Resistance Inspection
Disconnect the quick shifter sensor lead connector.
Connect a digital meter [A] to the quick shifter sensor lead
Measure the quick shifter sensor resistance.
Quick Shifter Sensor Resistance
Connections: BL/Y lead [C] ←→ G lead [D]
209 ∼ 231 kΩ
If the reading is out of the standard, replace the sensor.
If the reading is within the standard, but the problem still
exists, replace the ECU (see ECU Removal/Installation in
the Fuel System (DFI) chapter).
Quick Shifter Sensor Circuit
2. Quick Shifter Sensor