Periodic Maintenance Procedures
Brake Hose and Pipe Replacement
Brake fluid quickly damages painted plastic sur-
faces; any spilled fluid should be completely
washed away immediately.
Brake Hose Fitting Bolt [A]
Brake Hose Banjo Bolts [B]
Mud Guard [C] (see Mud Guard Removal in the Frame
When removing the brake hoses [D], note the following.
Take care not to spill the brake fluid on the painted or
Temporarily secure the end of the brake hose to some
high place to keep fluid loss to a minimum.
Immediately wash away any brake fluid that spills.
When installing the brake hoses, note the following.
Avoid sharp bending, kinking, flatting or twisting, and run
the hoses according to Cable, Wire, and Hose Routing
section in the Appendix chapter.
There are washers on each side of the brake hose fitting.
Replace them with new ones.
Torque - Brake Hose Banjo Bolts: 25 N·m (2.5 kgf·m, 18
Fill the brake line after installing the brake hose (see
Brake Fluid Change).
PERIODIC MAINTENANCE 2-47