Immobilizer System (Equipped Models)
Ignition Key Collation Error
The ignition key 2 is successfully registered in the ECU.
The red warning indicator light (LED) and immobilizer
warning indicator [A] blink 3 times and stops for 1 sec-
ond and then repeat this cycle to indicate successful
programming of ignition key 2.
Turn to "OFF" the ignition switch and wait for period more
than 15 seconds.
The registration mode automatically ends.
The red warning indicator light (LED) goes off [A].
Remove the key registration unit, key registration adapter
and install the immobilizer/Kawasaki diagnostic system
Turn the ignition switch to "ON" with the registered igni-
Check that the engine can be started using all regis-
tered ignition keys.
Install the new ignition switch (see Immobilizer System
Case 3: When the ECU is faulty and has to be replaced.
Prepare a new ECU [A] and current registered ignition
The key registration unit is not required.
After replacing the ECU, be sure to register the 2 ignition
keys. If the 2 keys are not registered, the engine can
not be started.
Replace the ECU (see ECU Removal/Installation in the
Fuel System (DFI) chapter).
ELECTRICAL SYSTEM 16-83