2-22 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Hold the leads to the guides [A].
Fit the terminal and groove [B].
Tighten the screw [C] on both sides.
Fuel Pump Lead [D]
Fuel Reserve Switch Lead [E]
Fuel Hose Replacement
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Primary Fuel Hose [A]
Secondary Fuel Hose [B]
Be sure to place a piece of cloth around the fuel hose joint.
Wipe off the dirt of the surface [A] around the connection
using a cloth or a soft brush.
When removing with flat tip screwdriver
Insert the flat tip screwdriver [A] into slit on the joint lock
Turn the driver to disconnect the joint lock.
When removing with fingers
Open and push up [C] the joint lock with your fingers.
Prying or excessively widening the joint lock ends
for fuel hose removal will permanently deform the
joint lock, resulting in a loose or incomplete lock
that may allow fuel to leak and create the potential
for a fire explosion. To prevent fire or explosion
from a damaged joint lock, do not pry or excessively
widen the joint lock ends when removing the fuel
hose. The joint lock has a retaining edge that locks
around the housing.