7-10 ENGINE LUBRICATION SYSTEM
Oil Pressure Relief Valve
Oil Pressure Relief Valve Removal
Oil Pan (see Oil Pan Removal)
Oil Pressure Relief Valve [A]
Oil Pressure Relief Valve Installation
Apply a non-permanent locking agent to the threads of
the oil pressure relief valve, and tighten it.
Do not apply too much non-permanent locking
agent to the threads. This may block the oil pas-
Torque - Oil Pressure Relief Valve: 15 N·m (1.5 kgf·m, 11
Oil Pressure Relief Valve Inspection
Remove the oil pressure relief valve (see Oil Pressure
Relief Valve Removal).
Check to see if the valve [A] slides smoothly when push-
ing it in with a wooden or other soft rod, and see if it comes
back to its seat by spring [B] pressure.
Inspect the valve in its assembled state. Disassembly
and assembly may change the valve performance.
If any rough spots are found during above inspection,
wash the valve clean with a high flash-point solvent and
blow out any foreign particles that may be in the valve with
Gasoline and low flash-point solvents can be
flammable and/or explosive and cause severe
burns. Clean the relief valve in a well-ventilated
area, and take care that there is no spark or flame
anywhere near the working areas.
gasoline or low flash-point solvents to clean the
If cleaning does not solve the problem, replace the oil
pressure relief valve as an assembly. The oil pressure
relief valve is precision made with no allowance for re-
placement of individual parts.
Do not use