Install the third torque limiter spring [A].
Install the fourth torque limiter spring [A].
Replace the clutch hub nut [A] with a new one.
Hold the sub clutch hub [B] steady with the clutch holder
[C], and tighten the clutch hub nut.
Special Tool - Clutch Holder: 57001-1243
Torque - Clutch Hub Nut: 130 N·m (13.3 kgf·m, 95.9 ft·lb)
Install the following as shown.
Friction Plates (48 Lining Blocks) [#1, #10]
Friction Plates (36 Lining Blocks) [#2 ∼ #9]
Steel Plates (T = 2.9 mm, 0.11 in.) [#1 ∼ #7]
Steel Plates (T = 2.6 mm, 0.10 in.) [#8, #9]
Spring Seat [A]
The lining blocks [C] of the friction plate [#1, #10] are
smaller than them of the friction plates [#2
Install the spring seat and spring between first steel
plate and second steel plate.
If new dry friction plates and steel plates are in-
stalled, apply engine oil to the surfaces of each
plate to avoid clutch plate seizure.