5-26 ENGINE TOP END
Cylinder Head Installation
The camshaft cap is machined with the cylinder head,
so if a new cylinder head is installed, use the cap that
is supplied with the new head.
Install the dowel pins.
Replace the cylinder head gasket with a new one.
Replace the cylinder head bolt washers with new ones.
Apply molybdenum disulfide oil solution to both sides [A]
of the cylinder head bolt washers and the threads [B] of
the cylinder head bolts [C].
Tighten the M10 cylinder head bolts as shown sequence
[1 ∼ 10].
Torque - Cylinder Head Bolts (M10):
First: 30 N·m (3.1 kgf·m, 22 ft·lb)
Final: 58 N·m (5.9 kgf·m, 43 ft·lb)
Tighten the M6 cylinder head bolts as shown sequence
Torque - Cylinder Head Bolts (M6): 12 N·m (1.2 kgf·m, 106
Remove the O-ring [A] with a new one.
Apply grease to the O-ring and install it.
Dowel Pin [B]
Rear Camshaft Chain Guide [C]
Front Camshaft Chain Guide [D]
Torque - Front Camshaft Chain Guide Bolt (Upper) [F]: 25
N·m (2.5 kgf·m, 18 ft·lb)
Front Camshaft Chain Guide Bolt (Lower) [G]: 12
N·m (1.2 kgf·m, 106 in·lb)
Install the removed parts (see appropriate chapters).