Cylinder Head Cover
Replace the cylinder head cover gasket [A] with a new
Using a high flash-point solvent, clean off any oil or dirt
that may be on the liquid gasket coating area. Dry them
with a clean cloth.
Apply liquid gasket [B] to the cylinder head as shown.
Sealant - Liquid Gasket, TB1216B: 92104-1064
Install the new cylinder head cover gasket.
Make the application finish within 20 minutes when the
liquid gasket (TB1216B) to the mating surface of the
cylinder head cover is applied.
Install the cylinder head cover.
Replace the rubber washers with new ones.
Install the rubber washers [A] with the metal side faces
Tighten the cylinder head cover bolts following the speci-
fied tightening sequence [1 ∼ 6].
Torque - Cylinder Head Cover Bolts: 10 N·m (1.0 kgf·m, 89
When installing the sub covers [A], install them as follows.
Apply a non-permanent locking agent to the threads of
the sub cover bolts [C], and tighten them.
Torque - Sub Cover Bolts: 10 N·m (1.0 kgf·m, 89 in·lb)
Install the removed parts (see appropriate chapters).
ENGINE TOP END 5-15