3-62 FUEL SYSTEM (DFI)
Nozzle Assy Removal
Remove the fuel tank (see Fuel Tank Removal).
Disconnect the secondary fuel hose [A] from the delivery
pipe of the nozzle assy [B] (see Fuel Hose Replacement
in the Periodic Maintenance chapter).
Disconnect the secondary fuel injector connectors [C].
Nozzle Assy Mounting Bolts [D]
Nozzle Assy Installation
Replace the insulators [A] with new ones.
Install the secondary fuel injectors [B] onto the insulators.
Install the nozzle assy [A] onto the secondary fuel injec-
Press the fuel injector portions [B] to connect securely.
Set the joint pipe [C] so as to be parallel to the air cleaner
When installing the nozzle assy, apply force equally
to the both sides of the delivery pipes. If the resin
made delivery pipe is pushed strongly, it could be
Tighten the nozzle assy mounting bolts [D].
Torque - Nozzle Assy Mounting Bolts: 5.0 N·m (0.51 kgf·m,
Tighten the inside bolts firstly. Then tighten the outside
Run the leads correctly (see Cable, Wire, and Hose Rout-
ing section in the Appendix chapter).
Connect the secondary fuel hose to the delivery pipe of
the nozzle assy (see Fuel Hose Replacement in the Pe-
riodic Maintenance chapter).