Download  Print this page

M) Monitor Display And Monitor Output Signal; Output Terminal Function Selection - Mitsubishi Electric A800-E Instruction Manual

Hide thumbs

Advertisement

2.4
(M) Monitor display and monitor output
signal
Purpose
To assign functions to the output
terminals
2.4.1

Output terminal function selection

Use the following parameters to change the functions of the open collector output terminals, relay output terminals, or
virtual terminals of CC-Link IE Field Network Basic.
Pr.
Name
190
RUN terminal
M400
function selection
191
SU terminal
M401
function selection
192
IPF terminal
M402
function selection
193
OL terminal
M403
function selection
194
FU terminal
M404
function selection
195
ABC1 terminal
M405
function selection
196
ABC2 terminal
M406
function selection
313
DO0 output selection
M410

314
DO1 output selection
M411

315
DO2 output selection
M412


The initial value is for standard models and IP55 compatible models.

The initial value is for separated converter types.

For the other settings, refer to the Instruction Manual (Detailed) of the FR-A800/FR-F800 inverter.

The other available settings depend on the inverter. For details, refer to the description of Pr.190 to Pr.196 (Output terminal function
selection) in the Instruction Manual (Detailed) of the FR-A800/FR-F800 inverter.

The parameter is used when the CC-Link IE Field Network Basic is selected. (Refer to
Inverter-to-inverter linkup (LNK) signal
• The Inverter-to-inverter linkup (LNK) signal is available to check that the master-slave communication is established. (For
the details of the inverter-to-inverter link function, refer to
Master/slave
The inverter receives a response from all the slave
Master
inverters during initial communication.
Slave
The inverter returns a response to the master.
• To use the LNK signal, set "242 (positive logic) or 342 (negative logic)" in any of Pr.190 to Pr.196 (Output terminal
function selection) to assign the function to the output terminal.
NOTE
• Changing the terminal assignment using Pr.190 to Pr.196 (Output terminal function selection) may affect the other
functions. Set parameters after confirming the function of each terminal.
Output terminal function
assignment
Initial
value
0
RUN (Inverter running)
1
SU (Up to frequency)
Open
IPF (Instantaneous power
collector
2

failure/undervoltage)
output
9999
No function

terminal
3
OL (Overload warning)
FU (Output frequency
4
detection)
99
ALM (Fault)
Relay
output
terminal
9999
No function
9999
No function
9999
No function
9999
No function
page
Signal ON condition

(M) Monitor display and monitor output signal

Parameter to set
P.M400 to P.M406,
Pr.190 to Pr.196,
P.M410 to P.M412
Pr.313 to Pr.315
Initial set signal
Inverter-to-inverter linkup (LNK) signal:
242 (positive logic), 342 (negative
logic)

Inverter-to-inverter linkup (LNK) signal:
242 (positive logic), 342 (negative
logic)

page
57.)
72.)
Signal OFF condition
• The inverter does not receive a response from a slave
in communication.
• The inverter detects a signal loss.
• The inverter does not receive any request from the
master.
• The inverter detects a signal loss.
Refer to
page
13
Setting range
13
PARAMETER
2
GROUP
M

Advertisement

Table of Contents

This manual is also suitable for:

F800-e

Comments to this Manuals

Symbols: 0
Latest comments: