Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for dji Aeroscope
Summary of Contents for dji Aeroscope
- Page 1 Aeroscope Stationary Unit Installation User Guide V1.0 2018.05...
- Page 2 Contents Lightning Protection Step-by-Step Installation Guide Importing Certificates Temporary Setup © 2018 DJI All Rights Reserved.
-
Page 3: Lightning Protection
Type 1 Type 2 Type 3 If Aeroscope is not under the protection of the nearest lightning rod, a designated lightning induction system should be designed by a qualified professional. Finally, be sure to note the following: Ensure that rainwater cannot flow along the Antenna cable into the Aeroscope receiver. - Page 4 The diameter of the pole plus the insulation layer should be 120 mm to utilize the frames supplied with the stationary unit and antennas. Figure 1 shows some real examples of Aeroscope stationary unit installation sites. Figure 1 Installation examples 2.
- Page 5 Each 5.8GHz antenna has two antenna cable ports. The port marked “OUT” is for connecting to the Aeroscope unit, and the port marked “IN” is for connecting to the 2.4GHz antenna. Figure 6 shows the connection configuration and close-up view of a 2.4GHz antenna.
- Page 6 8. Connect the computer and the Aeroscope unit to the same router, or connect them directly via the Ethernet port. 9. After the Aeroscope stationary unit is found on the DJI Assistant 2 start page, set the server IP and Port in Network Settings>Server Network Settings.
- Page 7 4. Connect the computer and the Aeroscope unit to the same router or connect them directly via the Ethernet port. 5. After the stationary unit is found in Aeroscope, click it to enter the unit page. Under Advanced Functions, select the certificate. Import the certificate by selecting both files.
Need help?
Do you have a question about the Aeroscope and is the answer not in the manual?
Questions and answers