Kenmore 125.15884800 Use And Care Manual page 8

Step 4
Set the burner assembly onto the cabinet as
shown.
IMPORTANT: The burner tube must slide
properly onto the gas valve orifice as
shown.
Step 5
Secure the burner assembly with the three
1/4-20 X 5/8" bolts from the inside of the
cabinet. Securely tighten the bolts.
Step 6
Attach the loose igniter wire to the igniter on
the control panel as shown below.
Note: With the help of a friend, turn the
smoker body to its upright position.
Try to minimize stress on legs.
CAUTION: Make sure the valve gas
orifice slides and fits into the
burner tube.
Step 7
Set the smoke stack on top of the cabinet
and line it up with the corresponding holes.
Insert three 10-24 X 5/8" bolts through
smoke stack base and into cabinet. Secure
with three 10-24 flange nuts.
8
Burner Tube
Igniter
Gas Valve
Orifice