Installing Blade And Blade Guard - Craftsman 315.220100 Operator's Manual

10 in. stationary radial arm saw
Hide thumbs Also See for 315.220100:
Table of Contents

Advertisement

THUMBSCREW
CLAMP
BRACKET
SQUARENUT
1
CUP
WASHER
RECTANGLE
HOLE
CUP
TO
WASHER
LOOSEN
TO
TIGHTEN
CLAMPSHOWN
ASSEMBLED
SLOT
Fig. 25B
TABLE
SUPPORT
_NSTALUNG
BLADE
AND BLADE
GUARD
See Figures 26A - 26C.
[] Collect the blade and hardware that were removed
earlier. Place the inner blade washer, saw blade,
outer blade washer, and blade nut on the blade
arbor. See Figure 26A. Note: The concave side of
blade washers go against the blade.
[] Hold the blade arbor with one wrench and rotate
the other blade wrench counterclockwise
(up), to
tighten the blade nut. See Figure 26B. Note: Blade
arbor has left hand threads. Test the blade to make
sure it turns freely.
[] Use the bevel index knob (above the handle) and
the bevel lock lever (below the handle) to set and
lock the motor at 0°. The blade will be vertical.
[] Attach the blade guard over the blade so the riving
knife and pawls face front. See Figure 26A.
[] Tilt the guard approximately 45 down in the front,
place it over the blade, and rotate it to a horizontal
locked position.
[] Retighten the blade guard clamp screw, the long
thumbscrew located between the blade guard and
the motor.
[] Check that the guard is firmly seated in the groove
on the motor housing.
[] Tighten the guard clamp screw.
[] Replace the retaining screw and nut at the bottom
of the lower inner blade guard. See Figure 26C.
THUMBSCREW
BLADE GUARD
BLADE
RETAINING
SCREWAND NUT
RIVINGKNIFE
BLADE NUT
AND PAWLS
TO
LOOSEN_
BLADE
ROTATION
iNNERBLADE
WASHER
Fig. 26A
TO
TIGHTEN
Fig. 25C
BLADE
ARBOR
%'
BLADE
WRENCH(2)
Fig. 26B
CRRF_',_MRN
RADIAL SAW315,220100
34

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents