Table of Contents
Advertisement
MAN0604_Issue 09_02-2013
2110M8030
3.4.2 Sunshade
The sun shade can be used with other accessories in the range such as the Flow Housing, Weather
Protection and Collecting Cone, but should be attached before any other accessories are fitted, or
after their removal.
To fit the Sunshade accessory carry out the following procedure.
(1)
Remove the Certified Sensor cap or accessory.
The cap or accessory is held by means of a bayonet fitting. Unscrew 1/4 turn anticlockwise
and pull off.
(2)
Slide the Sunshade clamp over the sensor body.
The shade should be positioned so that the whole sensor is shielded.
(3)
Fit the supplied self-tapping screw through the Sunshade clamp's left-hand hole (looking from
the clamp end of the Sunshade).
The self-tapping screw is a K40x16PT Pan Flange PZ Head.
3. inSTAllATiOn
Certified
Sensor
Flow
Housing
47
Sensor
body
Sensor
cap
Apex
Hide quick links:
Advertisement
Table of Contents
