Sunshade; Oxygen Transducer Adaptor; Filters - Honeywell Apex Technical Handbook

MAN0604_Issue 09_02-2013
2110M8030

2.3.5 Sunshade

Part Number: 2110B2152
The Sunshade prevents excessive heating of the sensor by direct sunlight. Conforms to cSA c22.2
No. 152 when fitted to the Certified Sensor with specific cartridges installed. See specifications
for details.
The sunshade is fitted to the sensor body by means of a clamp.

2.3.6 Oxygen Transducer Adaptor

The Oxygen Transducer Adaptor is supplied with the Oxygen cartridge and is necessary because the
depth of the Oxygen cartridge is more than that of the other gas cartridges.
The adaptor is attached to the Certified Sensor by means of a bayonet fitting. The Oxygen cartridge is
fitted first and the sensor cap or accessory is then fitted to the adaptor by means of a bayonet fitting.

2.3.7 Filters

One of three different types of filter accessory can be fitted to the Certified Sensor in place of the rubber
seal inside the sensor cap or accessory.
The three different types of filter available are:
Mesh filter - Part Number: 2110B2170 - for use in harsh
environments. The filter prevents dirt from blocking the
cartridge sinter.
Hydrophobic filter - Part Number: 2110B2171 - for use
in environments where the cartridge front is likely to become
wet. The hydrophobic material allows gas to pass through but
not water. A hydrophobic filter is supplied with the Flow
Housing and must be used when calibrating sensors fitted
with flammable gas cartridges.
Caution: The sensitivity of some cartridges may be degraded by the hydrophobic filter.
Carbon filter - Part Number: 2110B2172 - for use in environments where significant
volatile compounds are present. The filter prevents the cartridge from being critically
affected.
2. OvERviEW
53mm
19
115mm
Apex