Installing Backstop; Installing Table Assembly - Craftsman 113.226424 Owner's Manual

......... SANDING
disc witl
=irmly int o position all 1 way
SANDING
OtSC
INSTALLING BACKSTOP
t. Locate backstop, hex bolt V4-20xIi2 inch lock-
washer, and a 1/4inch flat washer.
2. Hold backstop into position and fasten with
bott and washer as shown Do not overtight:
en_
WRENCH
BACKSTOP
LOCK BOLT
INSTALLING TABLE ASSEMBLY
1: Locate table: support- rod, set screw and
toggle bolt among loose parts.
2_: Insert rodin base as shown, leaving 5 inches
of rod extending outside base. Rotate rod so flat
surface on rod faces toward on-off switch.
BASE
ROD
3. Install toggle bolt in base and tighten.
!ii: i:i+_ i l ziii: _ii_(i_i ¸i • ii:: i :ii_iii_ ! iiii ¸:i(•!ii_:
10