Page 1
OF THE RANGE in regard to the installation of to combustible wall above the drawings. IS ENCLOSED IN THE ALSO THERE IS A AND BUILDING TO WITH- BY THE OF A LISTED DIS- COLOATION OR DAMAGE, MAY OCCUR. 8101 P590-60 (o8-o5-o1)
Installation Check the oven model number plate to see if the oven is approved for installation in mobile homes and/or recreational vehicles. If approved the following items are applicable. NOTE: Oven model number plate is located under broiler bottom. Mobile Homes...
Page 4
Connecting The Oven Gas Supply Installation of this oven must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1-1atest edition. In Canada the oven must be installed in accordance with...
There is a time lapse from 30 to 45 seconds after the thermostat is turned ON before flame appears at the oven burner. When the oven has reached the dial setting, the glowing ignitor will go OFF.
Page 6
1/2 inch distinct blue flame, figure 4. b. Oven burner flame can be checked as follows, without burner baffle in place: 1. Yellow flame on burner - open burner air shutter to the widest opening that will not cause the flame to lift or blow off the burner when cold.
1/2 Ibs./sq. in. (13.8 in. W.C.). POSITION A219-740 OVEN MANIFOLD PRESSURETAP FIGURE 7 remove plastic dust cover TO MUST BE Manifold Gas Pressure Pressure Of House Piping GAS _ FOR SOME OVEN MODELS FIGURE 8...
(See figure 9B). Use care to not over tighten. Over tightening can damage the coaxial pin inside the orifice hood. NOTE: On units using Eaton Oven Safety Valve, screw the valve orifice hood down tight against the valve body. (See figure 9D). It is important that the hood be turned down as far as it can go to insure that complete conversion has occurred.
Need help?
Do you have a question about the 8101 P590-60 and is the answer not in the manual?
Questions and answers