Connecting; How To Connect The Receiver - JTS RU-8011D Instruction Manual

5. Connecting

5-1 How to connect the receiver

1. Connect the audio output of receiver to mixer or amplifier
1.1
The XLR output jack or 6.3mm unbalance output jack can be selected to
connect the AF output to a mixer or amplifier.
1.2
(1) The XLR output jack or 6.3mm unbalance output jack can be selected
individually to connect the AF output to a mixer or amplifier for volume
control.
(2) Switch the "Mixed" on the back to ON. This allows to mix the RX1 and RX2
signals to RX1's 6.3mm non-balance output jack and then to a mixer or
amplifier for volume control.
2.Connect the power
2.1. Connect the AC/DC adapter:
Check that the DC current and voltage ratings of the adapter match the
label on the unit. Connect the DC terminal to the "DC input" port on the unit,
and the AC end to an AC socket.
2.2. Set the parameters:
Turn the power on and set the parameters of receiver according to the
setting instructions.
Caution! Secure the power cable on the fastening hook of anti-pulling clip in
order to prevent the power cable from falling.
21
/ ：
：