Motorola Telario TS3000 Installation Manual page 8

Integrated cordless telephone and two-way radio system
Table of Contents

Advertisement

-8
Power receptacles that are controlled by switches or timers should not be
used.
Power-Cord Protection – Route power-supply cords so they are not likely to
be walked on or pinched by items placed on or against them, paying particular
attention to cords at plugs, AC outlets, and the points where they exit from the
product.
Overloading – Do not overload AC outlets or extension cords, as this can
result in a risk of fire or electric shock.
Objects and Liquids – Never push objects of any kind into this product
through openings, as they may touch dangerous voltage points or short out
parts that could result in a fire or electric shock. Never spill liquid of any kind
on the Control Station.
Servicing – In each or any of the following conditions, contact qualified per-
sonnel or your authorized Motorola dealer immediately.
When the power-supply cord or plug is damaged.
If liquid has been spilled or objects have fallen into the Control Station or the
power supply.
If the Control Station or the power supply has been exposed to rain or water.
If the Control Station does not operate normally when following the operation
instructions.
If the Control Station or the power supply has been dropped or damaged in any
way.
When the Control Station exhibits a distinct change in performance.
Heat – The Control Station should be situated away from heat sources such as radi-
ators, heat registers, stoves, or other products (including amplifiers) that produce
heat.
If the Control Station power and telephone line connections have been interrupted
or disconnected for more than four (4) hours.
If the Control Station Red LED lights.
6880906Z38-O
Telario TS3000 Control Station Installation Manual
November, 1999

Advertisement

Table of Contents
loading

Table of Contents