Installation; Place The Biometric Reader; Power On - Hitachi PC-KCM50 User Manual

2. Installation of the Biometric Reader

2.1 Place the Biometric Reader

Install the Biometric Reader on a horizontal and stable surface. Ensure no light through a
window or from lamps can enter the scanning area of the Biometric Reader.
It is recommended that you use the Biometric Reader in the 300-1000 lx luminance range,
which is equivalent to the brightness suitable for reading a newspaper.
Important

Do not use the Biometric Reader in places where the Biometric Reader is exposed
to strong light such as outdoors, near windows or near a light source, which may
lead to an authentication failure.

2.2 Power On

Slide power switch (left side of the unit) to power on.
USB mode
With USB cable connection
(powered by USB)
Without USB cable connection
(powered by internal battery)
Important

Biometric Reader can't power up in USB mode without USB bus power.

Biometric Reader may generate a little heat due to the use of infra-red light inside,
but this will not cause malfunctions.

Do not connect more than one Biometric Readers simultaneously to one PC. If
more Biometric Readers are connected, they will not work properly.

After connecting the Biometric Reader to your PC, wait for at least 5 seconds
before performing any operation.
Power OFF Bluetooth mode
USB mode
- Power On
- Connected by USB
- Power Off
9 / 20
Power Switch
Power OFF Bluetooth mode
- Power On
- Power Off
- Connected by Bluetooth
- Power On
- Power Off
- Connected by Bluetooth