Basic Functions; General Information; General Maintenance; Safety Information - Philips AZ 1140 Manual

BASIC FUNCTIONS

Switching on and off
• Adjust the POWER slider to the desired sound source: CD,
TUNER or TAPE/
OFF
• The set is switched off when the POWER slider is in the
TAPE/ position and the keys on the tape deck are released.
OFF
™ The volume and tuner presets will be retained in the set's
memory.
Adjusting volume and sound
1. Turn the VOL control to increase or decrease VOLUME.
2. Adjust the DBB control to select dynamic bass boost on or off.
PHILIPS demo mode
1. On the set, press the CD STOP 9 button for 5 seconds.
™ PH..IL ..IPS scrolls across the display continuously.
2. To return to the current display you can either:
• press any function button on the front panel. This interrupts
the demo mode for 30 seconds;
• press the CD STOP 9 button for 5 seconds. PH..IL ..IPS
scrolls once before the demo mode is cancelled.

GENERAL INFORMATION

General maintenance

• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois
leather. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the
housing.

Safety information

• Place the set on a hard and flat surface so that the system
does not tilt. Make sure there is adequate ventilation to
prevent the system from overheating.
• The mechanical parts of the set contain self-lubricating
bearings and must not be oiled or lubricated.
6
.
GENERAL INFORMATION