Switching The Device On And Off - Siemens SIMATIC RF650M Operating Instructions Manual

Commissioning

4.3 Switching the device On and Off

4.3 Switching the device On and Off
Requirements for startup
The battery of the reader is charged and inserted as described in the section "Power supply
(Page 13)".
Note
Keep to the minimum charging time
Before switching the device on for the first time, you must insert the reader into the charging
unit and charge it for approximately five hours.
Switching the device on/off
To switch the reader on or off, press the On/Off button
takes a few seconds.
Automatic shutdown of the device
The RF650M mobile reader has an automatic suspend mode to save energy. With this, the
reader is changed to the following power statuses step-by-step:
Table 4- 3
Power status
User Idle
System Idle
Suspend
After being switched on again, the reader starts in the last active menu entry.
You can manage the energy statuses with "Start > Settings > Control Panel > Power". For a
detailed description of the power statuses, refer to the section "Power Management (PM)
(Page 29)".
18
Factory settings: Power statuses of the reader
Power line operation
1 minute
5 minutes
--
. After switching on, the power-up
Battery operation
1 minute
2 minutes
5 minutes
SIMATIC RF650M mobile reader
Operating Instructions, 04/2015, C79000-G8976-C404-01