Whirlpool AGB 648/WP Manual For Use And Installation page 21

6.3 Resin cycle (only for models equipped with water softeners)
During the execution of the regeneration cycle, it will not be possible to perform any operations. This cycle must
always be performed with the tank empty.
Refilling the supply of regenerating salt (for models equipped with water softeners)
Perform the salt refill when there is no water in the tank in order to keep wash water from entering the water
softener device; always unplug the power cable from the socket before performing the operation. Remember to
plug the power cable back into the socket after having performed the operation.
Caution: Use only specific salt. Do not use table salt.
The salt tank has a capacity of about 1 kg of granulated salt.
The salt tank is situated at the bottom of the wash tank. After having extracted the rack, unscrew the cap and pour
the salt through the provided funnel. Before screwing the cap back in place, remove any eventual salt residues in
proximity to the opening.
6.4 Total drainage at the end of the day
Do not turn off the dishwasher while water is still in the tank. Always drain it first. When finished using
the machine, after having performed the final drainage and eventual regeneration, turn the machine off
by pressing the on/off
Do not leave the machine on, inactive and unutilized for long periods of time.
With the machine off, open the door and remove the
overflow in order to empty the tank; once the tank
has been emptied, replace the overflow and close the
door.
Press the
the regeneration cycle starts. After about 20 minutes,
the regeneration cycle finishes and the machine shuts
off. Open the door, verify that the regeneration water is
in the tank and remove the overflow to empty the tank;
once the tank has been emptied, replace the overflow
and close the door. Deactivate the general wall switch.
Total drainage at the end of the day (models with
drain pump)
Turn the machine off by pressing the on/off
button, open the door, remove the overflow and hold
down the drain pump button
been emptied.
In order to reactivate the machine it is therefore
necessary to place the overflow back into the tank,
close the door and press the on/off
Otherwise, if finished using the machine, deactivate the
general wall switch.
Total drainage at the end of the day (models
without drain pump)
Turn the machine off by pressing the on/off
button, open the door, remove the overflow and wait for
the tank to empty. Place the overflow back into the tank
and close the door. Deactivate the general wall switch.
button, deactivate the wall switch and turn off the water interception faucet.
button: the led indicator light turns on and
until the tank has
button.
10