Table of Contents
Advertisement
OWNER'S MANUAL
Model SC-7500A
For 6 and 12-Volt Batteries
SpeedCharge
Fully Automatic
Microprocessor Controlled
Battery Charger with
Engine Starter
CAUTION:
Read all Safety Rules and Operating Instructions,
and follow them with each use of this product.
Schumacher Electric Corporation
Mount Prospect, IL 60056 U.S.A.
Send Warranty Product Repairs to:
Customer Service Returns
P.O. Box 280,1025 E. Thompson, Hoopeston, IL 60942-0280
Questions? Call Customer Service: 1-800-621-5485
computer
smart
2
a m p
S L O W
C H A R G E
12
30
™
75
a m p
E N G I N E
S T A R T
a m p
F A S T
C H A R G E
™
0099000621/0206
Advertisement
Table of Contents
Related Manuals for Schumacher SC-7500A SpeedCharge
Summary of Contents for Schumacher SC-7500A SpeedCharge
- Page 1 OWNER’S MANUAL Model SC-7500A For 6 and 12-Volt Batteries SpeedCharge Fully Automatic Microprocessor Controlled Battery Charger with Engine Starter CAUTION: Read all Safety Rules and Operating Instructions, and follow them with each use of this product. Schumacher Electric Corporation Mount Prospect, IL 60056 U.S.A.
-
Page 2: Table Of Contents
WARRANTY ... 16 PLEASE SAVE THIS OWNER’S MANUAL AND READ BEFORE EACH USE. Model SC-7500A Microprocessor Controlled, Fully Automatic Operation Battery Charger with Engine Starter Plus Battery and Alternator Tester offers features to accommodate the needs for home or light commercial use. This manual will explain how to use the battery charger safely and effectively. -
Page 3: Important Safety Instructions
Review cautionary markings on these products and on engine. This manual contains important safety and operating instructions for battery charger model SC-7500A. • WARNING: Handling the cord on this... -
Page 4: Personal Safety Precautions
• Always operate the battery charger in an open, well-ventilated area. • Never smoke or allow a spark or flame in the vicinity of the battery or engine. -
Page 5: Before Using Your Battery Charger
Your charger requires a 120V AC 2-prong wall outlet receptacle installed according to all local codes and ordinances. ASSEMBLING YOUR CHARGER Included with your battery charger are two cord wrap cleats for storage of the clamp cables. To install, align the two tabs to correspond with the two receptacles and push until you hear a snap. -
Page 6: Operating Instructions
NOTE: A marine (boat) boat battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use. IMPORTANT: Follow all safety instructions and precautions when charging your battery. Wear complete eye protection and clothing protection. Charge your battery in a well- ventilated area. -
Page 7: Charging Battery Removed From The Vehicle
POSITIVE battery post. 8. Clean and store the charger in a dry location. Your battery charger can be used to jump start your car if the battery is low. Fol- low these instructions on how to use the ENGINE START feature. -
Page 8: Using Your Battery Charger
0. The 75A START LED blinks once every second. During USING YOUR BATTERY CHARGER OVERVIEW Using this battery charger is very simple. First, connect the battery and AC power following the precautions listed under “OPERATING INSTRUCTIONS”. Then select the appropriate BATTERY TYPE and CHARGE RATE for your battery. -
Page 9: Charger Controls
If the charge mode is changed after charg- ing has started (by pressing the CHARGE RATE or BATTERY TYPE button), the charging process will be restarted. DISPLAY MODE SWITCH Use this switch button to set the function of the digital display to one of the following. •... -
Page 10: Control Panel Guide
CONTROL PANEL GUIDE... -
Page 11: Using The Built-In Battery Tester
Battery Council International scale. TESTING SEQUENCE There are four basic steps required to use the SC-7500A as a battery tester. 1. Connect the charger battery clamps to the battery. Be sure to follow all of the precautions listed under “OPERATING INSTRUCTIONS”. -
Page 12: Using The Built-In Alternator Tester
DISPLAY MODE button to set the tester to ALTERNATOR % and read the alternator percent. TESTER STATUS LEDs When the SC-7500A is operating as an alternator tester, the status LEDs light under the following conditions. • The CHARGED (green) LED will light if the output of the charging system is at the normally desired level. -
Page 13: Battery Percent And Charge Time
BATTERY PERCENT AND CHARGE TIME This charger adjusts the charging time in order to charge the battery completely, efficiently and safely. The microproces- sor automatically makes the necessary decisions. However, this section includes guidelines that can be used to estimate charging times. -
Page 14: Charging Tips
A minimal amount of care can keep your battery charger working properly for years. 1. Clean the clamps each time you are finished charging. Wipe off any battery fluid that may have come in contact with the clamps to prevent corrosion. -
Page 15: Troubleshooting
The battery is connected and the charger is on, but isn't charging. Indicator lights are lit in an erratic manner not explained in the “Using Your Battery Charger” section. The CHECK (red) LED always flashes before the battery is completely charged. -
Page 16: Warranty
MAKES THIS LIMITED WARRANTY TO THE ORIGINAL PURCHASER AT RETAIL OF THIS PRODUCT. THIS LIMITED WARRANTY IS NOT TRANSFERABLE. Schumacher Electric Corporation warrants this battery charger for one year from date of purchase at retail against defective material or workmanship. If such should occur, the unit will be repaired or replaced at the option of the manufacturer.