Software installation
2.1
Installing the SIMATIC NET PC software
SIMATIC NET PC software
To operate the CP in your PG/PC, you require the SIMATIC NET PC software.
To configure the CP, you require additional configuration software. You will find information
on the configuration software in the section Configuration (Page 21).
Condition
The plug and play function is activated in the BIOS of your computer.
Prior to hardware installation
Install the software as described in the installation manual "SIMATIC NET, PC Software".
You will find this installation manual on the Product Support pages under the following entry
ID:
42784913 (http://support.automation.siemens.com/WW/view/en/42784913)
You should also note the current information on the SIMATIC NET PC software on the
product support pages under the entry ID:
12660737 (http://support.automation.siemens.com/WW/view/en/12660737)
After the hardware installation
After installing the CP, your PG/PC automatically searches for a suitable driver.
1. Follow the instructions of the Hardware Wizard of Windows.
2. Do
2.2
Uninstalling the SIMATIC NET PC software
Condition
The SIMATIC NET PC software is installed on the PG/PC.
CP 5613 A3 / CP 5614 A3
Operating Instructions, 10/2012, C79000-G8976-C277-01
not
activate the search for drivers on the Internet.
2
15