To adjust the tension
10. Tighten the saw chain. Refer to
of the saw chain on page 17 for instructions.
To replace the saw chain
1. Turn the locking knob counterclockwise and remove
the protective cover (A).
C
E
B
D
A
2. Remove the guide bar with the saw chain attached.
3. Remove the saw chain from the guide bar.
4. Put a new saw chain in the groove of the guide bar.
5. Install the guide bar and gear (B) onto the guide bar
pin (E).
6. Install the saw chain around the drive sprocket.
Make sure that the cutting teeth point in the direction
away from the drive sprocket (C).
7. Install the protective cover (A) and turn the locking
knob clockwise.
To adjust the tension
8. Tighten the saw chain. Refer to
of the saw chain on page 17 for instructions.
To sharpen the saw chain
Information about the guide bar and saw chain
Replace a worn or damaged guide bar or saw chain with
the guide bar and saw chain combination recommended
by Husqvarna. This is necessary to keep the safety
Accessories on page
functions of the product. Refer to
22 , for a list of replacement bar and chain
combinations that we recommend.
•
Guide bar length, in/cm. Information about the guide
bar length can usually be found on the rear end of
the guide bar.
•
Number of teeth on bar tip sprocket (T).