Sony XR-CA300 Operating Instructions Manual page 23

RDS
Problem
The SEEK starts after a few
seconds of listening.
No traffic announcements.
PTY displays "NONE."
CD/MD playback (XR-CA300/CA310 only)
Problem
The sound skips.
Error displays (when an optional CD/MD unit is connected)
(XR-CA300/CA310 only)
The following indications will flash for about five seconds, and an alarm sound will be heard.
Display
NO MAG
NO DISC
* 1
ERROR
1
*
BLANK
RESET
NOT READY
HI TEMP
1 When an error occurs during playback of a CD or MD, the disc number of the CD or MD does not appear
*
in the display.
2 The disc number of the disc causing the error appears in the display.
*
If the above-mentioned solutions do not help improve the situation, consult your nearest Sony
dealer.
Cause/Solution
The station is non-TP or has a weak signal.
t Press (AF) or (TA) repeatedly until "AF-OFF" or
"TA-OFF" appears.
•Activate "TA."
•The station does not broadcast any traffic announcements
despite being TP.
t Tune to another station.
The station does not specify the programme type.
Cause/Solution
A dirty or defective disc.
Cause
The disc magazine is not inserted in
the CD/MD unit.
No disc is inserted in the CD/MD unit.
A CD is dirty or inserted upside
2
down.*
An MD does not play because of some
problem.* 2
A CD/MD cannot play because of
some problem.
No tracks have been recorded on an
2
MD.*
The CD/MD unit cannot be operated
because of some problem.
The lid of the MD unit is open or MDs
are not inserted properly.
The ambient temperature is more than
50°C.
Solution
Insert the disc magazine in the CD/
MD unit.
Insert discs in the CD/MD unit.
Clean or insert the CD correctly.
Insert another MD.
Insert another CD/MD.
Play an MD with tracks recorded on
it.
Press the reset button of the unit.
Close the lid or insert the MDs
properly.
Wait until the temperature goes
down below 50°C.
23