SATO CL608e Operator's Manual page 31

Section 2. Installation
OPERATOR PANEL
OPTION
CONNECTOR
Note: DSW1 (RS232 Parameter Select) is located on the RS232 Interface Board.
The CL408e/CL412e Operator Panel consists of one two-color (red and green)
LED indicator, two momentary contact switches, two DIP switches (a third is located
on the RS232 interface card), four adjustment potentiometers and one LCD Display.
All of these are accessible from the front of the printer, however some are not
accessible unless the front cover is open. They are used to set the printer operating
parameters and to indicate the status of the printer to the operator. After you power
on the printer, familiarize yourself with the keys and indicators as it will help you
understand the configuration process.
PRINT:
OFFSET:
PITCH:
Page 2-14
LINE
x x
PRINT OFFSE
DSW2 DSW3
x
Located behind the Front Access Door. Potentiometer
to adjust print darkness (fine tuning).
Located behind the Front Access Door. Potentiometer
to adjust amount of back/forward feed for
dispenser/cutter/tear-off bar position (+/- 3.75 mm)
Located behind the Front Access Door. Potentiometer
to adjust home position of the label (+/- 3.75 mm).
Affects stop position of label feed, print position and
dispense position.
PN 9001074 Rev. B
CL408e and CL412e
LCD
DISPLAY
PANEL
TWO-COLOR
STATUS LED
FEED
x
LABEL TAKEN
PITCH
THRESHOLD
ADJUST
TAKEN LED
SATO CL Series "e" Printers
LABEL