Connecting The Ac Power Cord - Sanyo PLV-Z4 Owner's Manual

Installation

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-120V or 200-
240V AC and it automatically selects a correct input voltage. It is
designed to work with the single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being supplied, consult
your authorized dealer or service station.
Connect the projector with all peripheral equipment before turning
on the projector. (See pages 16 ~ 17 for connection.)
CAUTION
For safety, unplug the AC power cord when the projector is not
in use.
When the projector is connected to an outlet with the AC power
cord and the Main On/Off switch is on, it is in stand-by mode
and consumes a little electric power. Turn the Main On/Off
switch off when the projector is not in use.
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and a proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
Projector side
To power cord
connector on your
projector.
14
For the U.S.A. and Canada
Ground
To the AC outlet.
(120 V AC)
HDMI
Connect the AC power cord (supplied) to the
projector.
The AC outlet must be near this equipment and must
be easily accessible.
AC outlet side
For Continental Europe
To the AC outlet.
(200 - 240 V AC)
S-VIDEO
COMPON
COMPUTER
COMPON
Y Pb/Cb Pr/Cr
VIDEO
For the U.K.
To the AC outlet.
(200 - 240 V AC)