Basic Operation; Turning On / Off Projector; Turning On The Projector - Sanyo PLV-75/PLV-80 Owner's Manual

BASIC OPERATION

1
Complete peripheral connections (with a computer, VCR,
etc.) before turning on the projector.
2 Connect the projector's AC power cord into an AC outlet.
The LAMP Indicator lights RED, and READY Indicator lights
GREEN.
3
Press the POWER ON-OFF button on the top control or on
the remote control to ON. The LAMP Indicator dims, and the
cooling fans start to operate. The preparation display
appears on the screen and the count down starts.
4 After the count-down, the input source that was selected last
and the Lamp control status icon (see page 40) appear on
the screen.
If the projector is locked with a PIN code, PIN code Input
Dialog Box will appear. Enter the PIN code as instructed
below.
Enter a PIN code
Select a number by pressing the POINT LEFT/RIGHT button and fix the
number with the SELECT button. The number will change to "✳". If you
fixed a wrong number, move the pointer to "Set" or "Clear" once by
pressing the POINT DOWN button, then return to "PIN code". Enter the
correct number again.
Repeat this step to complete entering a four-digit number.
When the four-digit number is fixed, the pointer will automatically move to
"Set". Press the SELECT button so that you can start to operate the
projector.
If you entered a wrong PIN code, "PIN code" and the number (✳✳✳✳) will
turn red and disappear. Enter a correct PIN code all over again.
What is PIN code?
PIN code is a security code using Personal Identification Number that
allows the person who knows it to operate the projector. Setting PIN code
prevents others except the specific users from operating the projector.
A PIN code consists of a four-digit number. Refer to PIN Code Lock
function in Setting on page 42 for locking operation of the projector with
your PIN code.
CAUTION ON HANDLING PIN CODE
If you forget your PIN code, the projector can no
longer be started. Set a new PIN code with special
care, write it down in column on page 59 of this
manual, and keep it at hand. Should the PIN code be
missing or forgotten, consult your dealer or service
center.
20

TURNING ON / OFF PROJECTOR

TURNING ON THE PROJECTOR

16
The preparation display disappears after 20 ~ 30 seconds.
Selected Input Source and Lamp control
Lamp control status
For model PLV-80/PLV-80L only.
(See page 40 for Lamp control.)
PIN code Input Dialog Box
Pointer
After the OK icon
disappears, you can
operate the projector.