Connection To Mains And Loads (1000Va To 3000Va); Figure 8 Example Of Installation Of Plug & Play Product - Toshiba T1000 Series Installation And Operation Manual

12.3

CONNECTION TO MAINS AND LOADS (1000VA TO 3000VA)


Ensure that the UPS is disconnected from mains and loads while connecting the
External Battery Cabinet, if needed.

Use the battery cable that comes with the External Battery Cabinet to connect the
External Battery Cabinet to the UPS. Connect a second battery cabinet to the first
one with the cable provided if more than one is to be installed.

Be aware of UPS parameters and changing the battery pack quantity when using
the External Battery Cabinet (see Section 13)

Connect the input cable to the UPS and connect the other end to a grounded outlet.
The batteries will automatically charge when connected to the mains. Please realize
that although you may start using the UPS immediately, maximum back-up time will
still not be available, so it is recommended to charge the batteries for a minimum of
8 hours before use.
 If unit instantly shows a "Site Wiring Fault", rotate the connector (see Section 13.5).

After charging the UPS, connect the load to the UPS.

Do not connect any devices that have the possibility of overloading the UPS or
drawing half-wave rectified current, such as hair dryers or vacuum cleaners.

Should computer or alarm connections be used, use connections according to
Section 12 of the manual provided with that option. The connections can be referred
to on the rear panel.

The installation is now complete.
T1000 Series UPS 1000-3000VA Installation and Operation Manual – 94086-001
Figure 8 Example of Installation of Plug & Play Product
26