Table of Contents
Advertisement
Chapter 5 Network Capture
error information
error messages
Set up the parameter.
It has not been registered to
monitor as a group.
Cannot be displayed as moni-
tor is under display.
Cannot connect to monitor.
Cannot transfer data to moni-
tor.
Cannot receive data from mon-
itor.
Other PC has authority.
Cannot complete "Network
Communication".
Other PC has authority. Cannot
obtain authority.
The server name or address
could nt be resolved.
Invalid port number
Monitor
has not started Network
Communication. Close the window
and open it again.
0
Network capture function is for projector originally. So some error
messages include word "PJ". Here "PJ" means "Monitor".
Cause and corresponding
Error when executing the communication. The parameter setting
(host name, capture port) has not been set.
heck parameter setting (
C
Error when executing Start Communication or Start real time cap-
ture. The IP address of the computer has not been registered.
egister the IP address by using the web browser (
R
Error when executing Start Communication or Start real time cap-
ture. The other capture, viewer or advanced card imager function
is now operating.
ait until the communication function is available.
W
Cannot establish the connection with the network unit when
executing the Start communication, End communication, Capture
transfer, Start real time capture or End real time capture.
heck connection of the network cable.
C
Cannot transfer the data to the network unit when executing the
Start Communication, End Communication, Capture transfer, Start
real time capture or End real time capture. The time out period is
10 seconds.
heck connection of the network cable.
C
Cannot receive the data from the network unit when executing
the Start Communication, End Communication, Capture transfer,
Start real time capture or End real time capture. The time out
period is 10 seconds.
heck connection of the network cable.
C
When executing the End communication, you cannot quit the
communication because other computer has an authority
Other computer has an authority.
When setting the parameter, the computer cannot find the set-
ting host name or IP address in the network.
se available host name or IP address.
U
When setting the parameter, the reserved port number is speci-
fied.
heck parameter setting (
C
The monitor might have turned off during the communication.
heck monitor power and restart executing "Start communication".
C
p.67)
p.67)
p.72)
Advertisement
Table of Contents
