Package Contents - D-Link DSN-3200 Quick Installation Manual

Quick Installation Guide
iSCSI SAN ARRAy wIth 15 SAtA BAyS

Package Contents

If any of the items are missing,
DSN-3200/ CD ROM
DSN-3400
Connect to DSN Series SAN Array
A. to install the hard drives:
Place the hard drives into the drive trays and secure with mounting screws on the drive trays. then
gently insert the assembled drive trays into the enclosure until the latch clicks.
B. DSN-3200 :
Attach an Ethernet cable to 1GbE data port 0 on the rear panel and to your server or SAN switch.
Facing the rear of the SAN array, the data ports are on the left side. to connect additional data ports
to your SAN array, repeat this step using another Ethernet cable and the next data port.
DSN-3400 :
Attach a XFP transceiver with a single or multi mode optical fiber cable to the XFP host network
port on the rear panel and to your server or SAN switch. Facing the rear of the SAN array, the host
network port is on the left side.
C. the management port can be connected to the server either by directly attaching a crossover cable,
or via a switched infrastructure using a standard Ethernet cable. Facing the rear of the SAN array, the
management port is on the right side of the I/O panel. By default, this port is set to the IP address of
192.168.1.1. this can be changed using the web based wizard.
DSN-3200/DSN-3400
please contact your reseller.
Power
Console
cables
cable
host Network Connections
host
Network
Rx/Link
Keys
Diagnostic Port
Mgmt
Ethernet
Diagnostic Port
2
Rack mount screws
slide rails
Mgmt
Ethernet