Precautions; Stand Removal / Wall Mounting; Stand Removal/Wall Mouting; Getting Started - Sanyo DP42849 Owner's Manual

STAND REMOVAL AND WALL MOUTING
Tools Needed: Phillips screwdriver
IMPORTANT NOTE:
Place HDTV face down on a padded or cushioned surface to protect the screen and finish.
Wall mounting of the HDTV must be performed by a skilled person.
DP42849
DP46849
1 Remove the four (4) screws securing the foot
stand. CAUTION: Hold the stand firmly as you
remove the last screw.
2 Use the screws you removed when detach-
ing the stand to secure the HDTV to a wall
mounting kit (kit not included.)
VESA standard interface: 400 x 400
Mounting screws measurements:
M6 (6mm) Diameter, Length—16mm (maximum)

GETTING STARTED

Install batteries in the remote control
( 2 "AAA", not included)

PRECAUTIONS

To ensure safe operation, please observe
the following precautions:
• Replace both batteries at the same
time. Do not use a new battery with
a used battery.
• There's a risk of explosion if a battery
is replaced by an incorrect type.
• Do not expose the Remote Control unit to moisture
or heat.
• Be sure to match the "+" and "
ies with marks inside the remote control.
No. 3
–
" signs on the batter-
Need help?
(OPTIONAL)
DP52449
1 Remove the four (4) screws securing the foot
stand. CAUTION: Hold the stand firmly as you
remove the last screw.
2 Use the screws you removed when detach-
ing the stand to secure the HDTV to a wall
mounting kit (kit not included.)
VESA standard interface: 400 x 400
Mounting screws measurements:
M6 (6mm) Diameter, Length—16mm (max.)
ANTENNA CONNECTION FOR
OFF-AIR SIGNALS OR CABLE
ANTENNA
CABLE
Note: The tuner in this HDTV can receive digital and
analog off air signals from an antenna. It can also
receive analog or ClearQAM cable channels from
a direct Cable TV connection.
www.sanyoctv.com
ANALOG / DIGITAL
ANTENNA IN
5
1-800-877-5032