GETTING STARTED (REQUIRED INITIAL SETUP)
1
Install batteries in remote control (2AA, not included).
PRECAUTIONS
To ensure safe operation, please observe the following
precautions:
Replace both batteries at the same time. Do not use a new
battery with a used battery.
Risk of explosion, if battery is replaced by an incorrect
type.
Do not expose the Remote Control Unit to moisture or
heat.
2
Connect Signal to the DTV's Integrated Analog / Digital
75 ohm Antenna Input terminal.
CABLE BOX OR SATELLITE BOX
THE TUNER IN THIS DTV CAN RECEIVE:
1. Digital and / or Analog Off-Air Signals from an RF
antenna.
OR
2. Analog or ClearQAM cable channels.
Note:You must search for ClearQAM channels using
the "Digital Cable Search" menu option.
RF ANTENNA
OR
CABLE
OR
DTV RIGHT SIDE (VIEWED FROM BACK)
OR
3. The output from a VCR or cable box.
Digital signals from a Set-top (STB) Box should be
received through the Component jacks.
This DTV can receive ANY unscrambled RF signal
being broadcast.
(CONTINUED ON NEXT PAGE.)
Match the "+" and "–"
signs on the batteries with
marks inside the remote
control.
ANALOG / DIGITAL
ANTENNA IN
14