Tying Strength Setting; Remaining Battery Notification; Assembly; Loading The Tie Wire (Wire Reel) - Makita DTR180 Original Instructions Manual

When you pull the switch trigger, the tool performs the next
sequential operations as follows, and the tool stops automatically.
1. Feed the wire.
2. Cut the wire.
3. The hook holds and twists the wire.
4. The hook returns to the original position.

Tying strength setting

CAUTION:
Be sure to lock the trigger before start-
ing the adjustment. When you turn the power on, never
bring your limbs or face close to the binding or rotating
parts of the tool tip. Otherwise, you may be injured.
You can set the tying strength by adjusting the tying strength
adjusting button. Tying strength is shown on the display panel.
1
► 1 . Tying strength adjusting button 2. Display panel
If the wire is broken off, tying strength will be lost. After
tying, check the twisted portion for breakage.
If the wire is broken off, adjust the tying strength using
the tying strength adjusting button, and tie the rebars
again.

Remaining battery notification

When the battery voltage drops below the required level,
the tool will stop operating, an error tone will sound, and
the number "4" will appear on the display panel. The error
tone will continue to sound until the power is turned off.
NOTE: If the ambient temperature is extremely low,
the error tone may sound even when the battery
contains sufficient power.

ASSEMBLY

CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.

Loading the tie wire (wire reel)

CAUTION:
tie wires and accessories, be sure to turn the
power off, lock the trigger, and remove the battery
cartridge. Failure to do so may cause an accident.
NOTICE:
ine tie wires (annealed wires) may cause the tool
to malfunction.
1. Push the release lever, and lock it with the lock lever.
2
► 1 . Release lever 2. Lock lever
When you push the release lever, a gap is created
between the left and right feed gears.
► 1 . Release lever 2. Lock lever 3. Feed gears
9 ENGLISH
Always be sure that the tool is
Before mounting or dismounting
Using wires other than Makita's genu-
1
2
2
1
3