Related Manuals for geminox EBS series
Summary of Contents for geminox EBS series
- Page 1 We reserve the right to modify the characteristics of the equipment supplied without notice or as part of the continued development of our products.
- Page 2 DOMESTIC HOT WATER EFFICIENCY Volume Volume drawn Heat Continuous drawn at Specific flow Pre-heating at 40 C in 10 output flow rate at 40 Load time C in 1 rate time at 60 minutes at ∆T at 60 Models hour (*1) (*2) Storage 65...
-
Page 3: Electrical Connections
Please refer to the manufacturer’s literature supplied with each item you choose to install or please contact the Geminox-UK Technical helpline for further assistance on + 44 (0)1372 722277. - Page 4 EBS WRc APPROVAL AMENDMENT TO MANUAL WRc Approval No : 0210132 **NOTE TO INSTALLER** : Please read fully prior to commencing installation. Leave manual with householder after installation. TECHNICAL INFORMATION Table 1 MODEL EBS 100 EBS 150 EBS 200 EBS 300 Operating Pressure 3.5 Bar 3.5 Bar...
- Page 5 No other immersion, other than our EBS Immersion Heater should be used on our EBS cylinders. The EBS range of cylinders is ideally suited for connection to our Geminox boilers to match the coil ratings. However, connection to non – Geminox boilers can be carried out if required.
- Page 6 Results of the reheat time 1-50 – 222 13 mins 16 mins • This unit is only to be used with our oil or gas boiler with a thermostatic control. It should not be used with a solid fuel appliance. •...
- Page 7 Please Note The Geminox range of products are designed to be used in installations where the complete system is supplied by Geminox therefore when used in conjunction with other products some slight alterations to the Electrical installation may have to be made.
- Page 8 HYDRAULIC CONNECTIONS FOR CYLINDERS When the system installed is “Unvented” it is necessary to fit the “unvented kit” on the cold water supply. The “Unvented kit” contains pressure reducing valve, non-return valve, pressure relief valve and optional use balanced cold water connector. It is good practice to fit the “unvented kit”...
- Page 9 Fig. 3 1” Unvented kit for EBS cylinders Fig. 4 1” Unvented kit for EBS cylinders We reserve the right to modify the characteristics of the equipment supplied without notice or as part of the continued development of our products.
- Page 10 Whilst in heating cycle using the immersion heater the Green selector switch LED will illuminate and extinguish once desired temperature is reached. Fig. 5 ¾” Safety zone valve Fig. 6 1” Safety zone valve We reserve the right to modify the characteristics of the equipment supplied without notice or as part of the continued development of our products.
- Page 11 Please Note The Geminox range of products are designed to be used in installations where the complete system is supplied by Geminox therefore when used in conjunction with other non-Geminox products some slight alterations to the electrical installation may have to be made.
- Page 12 We reserve the right to modify the characteristics of the equipment supplied without notice or as part of the continued development of our products.
- Page 13 Fig. 8 We reserve the right to modify the characteristics of the equipment supplied without notice as part of our continued development of products We reserve the right to modify the characteristics of the equipment supplied without notice or as part of the continued development of our products.
- Page 14 We reserve the right to modify the characteristics of the equipment supplied without notice or as part of the continued development of our products.
- Page 15 We reserve the right to modify the characteristics of the equipment supplied without notice or as part of the continued development of our products.
- Page 16 NOTE: THIS DETAIL IS ONLY TO BE USED WHERE THERE IS NO OTHER ALTERNATIVE. IT IS STRICTLY SUBJECT TO LOCAL DISPENSATION AND APPROVAL MUST BE SOUGHT FROM NHBC AND BUILDING CONTROL INSPECTOR PRIOR TO INSTALLATION TUNDISH - VISIBLE POINT OF DISCHARGE HepvO VALVE MUST BE VERTICAL AND ADJACENT TO THE WATER...
Need help?
Do you have a question about the EBS series and is the answer not in the manual?
Questions and answers