Table of Contents
Advertisement
INSERTING AND EJECTING THE DISK
Be sure to insert the disk before using the digital disk camera. Use only iD PHOTO disks with the
iD PHOTO logo mark (_). No other type of disk can be used with this digital disk camera
(IDC-1000ZEX, IDC-1000ZE, IDC-1000ZU). Also, before using the supplied disk or any other disk
for the first time, always format it first with your digital disk camera (see pages 155, 157).
Inserting the disk
1
Push the EJECT lever in the direction of the arrow.
œ The disk holder opens slightly. Gently open the disk holder in the direction of the arrow
given below.
œ A protective spacer is placed inside the disk holder at the time of purchase. Remove this
spacer if it is present.
2
Insert the disk into the disk holder.
œ Insert the disk in the direction of the arrow given
(l mark) with its label facing outwards.
œ Be sure to insert the disk all the way in until it is
properly seated.
3
Push the disk holder closed.
œ When the disk is inserted, the disk mark in the
mode display panel lights.
NOTE
If the disk mark turns
œ The disk mark in the mode display panel rotates when a disk is inserted.
While the mark is rotating, data on the disk is being read and recording cannot
be performed. Wait until the disk mark stops rotating before using the digital
disk camera. (The digital disk camera can be turned on while the disk mark is
rotating.)
EJECT lever
Disk holder
slightly opens
Protective
spacer
Label side
l mark
Mode display
panel
Disk mark
30
English
Advertisement
Table of Contents
