Telephone Line Connection; Tone/Pulse Setting; Mounting On A Wall - Sanyo CLT-U12 Instruction Manual

GETTING STARTED

Telephone line connection

Once the handset battery is fully charged, connect the telephone line cord to the
TEL LINE jack on the back of the base. Plug the other end into a telephone outlet.

Tone/pulse setting

1. If you have Pulse (rotary) service, you will need to set the dial mode to pulse.
If you have Touch-Tone service, do nothing as your phone has been set to
Tone prior to shipment. If you do not know which type of service you have,
contact your local telephone company.
2. To change to Pulse or Tone service, See Tone/pulse setting, page 11.

Mounting on a wall

Do not attempt to wall mount the phone before initial 12-hour charging is complete.
1. Remove the handset from the base and set aside.
2. Align the four slots on the bottom of the base with the four hook-tabs on the
bracket.
3. Insert the hook-tabs into the slots and push up until the bracket snaps
securely into place.
4. Turn the base over and unplug the AC adaptor and telephone cords. Run the
cords through the square hole on the wall mount. Plug them back in to the
base.
Note: If you use Pulse (rotary) dial service, See Tone/pulse setting, page
11.
7