Traveling Out-Of-Range - Sanyo CLT-E23 Instruction Manual

UP383BA_0.book Page 42 Thursday, May 26, 2005 10:48 AM
BASICS
Initially make your call with the pulse dialing mode. Once your call connects, press
/tone/ . Enter the desired number. These digits will be sent as tone dialing. Once the
*
call ends, the tone mode is canceled and pulse dialing mode resumes.
Notes:
• The tone feature only applies when the dial mode is set to pulse.
• This special number can be stored in a memory location. This is referred to as Chain Dialing
(see page E56).

Traveling Out-of-Range

During a call, as you begin to move your handset too far from your base unit, noise may
increase. If you pass the range limits of the base unit, you will hear a beep and see
on the display, and then the handset returns to standby mode. You may return to the
R a ng e
call if you move your handset within the range limits of the base and press talk/flash or
speaker within 30 seconds.
[ E 4 2 ] B a s i cs
Ou t of