Initial Programming; Language; Screen Contrast - Sanyo CLT-2419 Instruction Manual

CLT-2419-2423E-NEW 3/14/03 3:32 PM

INITIAL PROGRAMMING

Before using this telephone 6 initial settings must be completed on the
base: Language, Screen contrast, Area code (This is required to use
Caller ID service from your telephone company), Ringer tone and
Time.
Note: The Language selection and Ringer tone setting must be done
separately for the handset and for the base.
Language setting
On the base:
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROGRAM on the base.
1 1 E E N N G G L L I I S S H H 2 2 F F R R A A 3 3 E E S S P P shows on screen.
Press CID ▲ or ▼ , or the number keys to select the desired
3.

language.

4. Press FLASH/PROGRAM to confirm.
On the handset:
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG on the handset.
1 1 E E N N G G L L I I S S H H 2 2 F F R R A A 3 3 E E S S P P shows on screen.
Press CID ▲ or ▼, or the number keys to select the desired
3.
language.
4. Press FLASH/PROG to confirm.
Screen contrast setting
To adjust the base screen only.
The handset screen is not adjustable.
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROGRAM twice.
S S E E T T C C O O N N T T R R A A S S T T shows on screen.
Press CID ▲ or ▼, or the 1 or 2 number key to select the desired
3.
contrast.
4. Press FLASH/PROGRAM to confirm.
Page 10
10
INITIAL PROGRAMMING
Area code setting
For proper Caller ID operation, you must enter your area code. This
setting can only be done from the base.
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROGRAM three times.
S S E E T T A A R R E E A A C C O O D D E E shows on screen.
3. Enter your 3-digit area code using the number keys.
4. Press FLASH/PROGRAM to confirm.
Ringer tone setting
On the base:
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROGRAM four times. S S E E T T R R I I N N G G E E R R T T O O N N E E
shows on the screen.
Press CID ▲ or ▼, or press the 1, 2, or 3 number keys to select
3.
the desired ringer tone.
4. Press FLASH/PROGRAM to confirm.
On the handset:
1. Make sure the phone is OFF (not in TALK mode).
2. Press FLASH/PROG two times.
S S E E T T R R I I N N G G E E R R T T O O N N E E shows on the screen.
Press CID ▲ or ▼, or press the 1, 2, or 3 number keys to select
3.
the desired ringer tone.
4. Press FLASH/PROG to confirm.
Time setting
The time and date are programmed automatically when Caller ID
information is successfully received after setup.
1. Phone must be OFF (not in TALK mode).
2. Press FLASH/PROGRAM on the base five times.
S S E E T T T T I I M M E E shows on the screen.
3. Enter the hour and minutes using the number keys (0 – 9).
Press CID ▲ or ▼ key to select AM or PM.
4.
5. Press FLASH/PROGRAM to confirm.
11