Table of Contents
Advertisement
CLT-2422E-NEW
7/16/02
9:08 AM
DIRECTORY
Inserting a pause in the dialing sequence
Press PAUSE twice to insert a delay in the dialing sequence of a
stored telephone number when a pause is needed to wait for a dial
tone (for example after you dial 9 for an outside line, or to wait for a
computer access tone). Each pause counts as 1 digit in the dialing
sequence. P P shows on screen.
Note: Make sure to press PAUSE twice to enter a pause. If you press
PAUSE once while entering a directory name/number, it will enter a #
(number sign).
Replacing a directory entry with a Caller ID entry.
Use CID ▲ or ▼ to select a specific Caller ID entry.
1.
2.
Press MEM.
S S E E L L E E C C T T M M E E M M O O 1 1 - - 0 0 shows on screen.
3.
Select the memory location you want to replace and press MEM.
R R E E P P L L A A C C E E M M E E M M O O ? ? shows on screen.
4.
Press MEM again to confirm and save.
Changing a stored number
Use the same procedure as you do to store a name/number in
the directory.
Making calls from the directory
1.
Make sure the phone is OFF (not in TALK mode).
2.
Press MEM.
Use CID ▲ or ▼, to scroll to the desired memory location.
3.
4.
Press TALK/CALL BACK on the handset or CALL BACK on the
base.
or
1.
Make sure the phone is ON by pressing TALK on the handset or
SPEAKER on the base.
2.
Press MEM.
3.
Press a number (0 – 9) for the desired memory location.
The number dials automatically.
Page 26
26
DIRECTORY
Reviewing and deleting directory contents
1.
Make sure the phone is OFF (not in TALK mode).
2.
Press MEM.
Use CID ▲ or ▼ to scroll through the directory until the desired
3.
name/number is shown, or use the number pad to select a
memory location. M M E E M M O O # # , the selected telephone number and
name show on screen.
4.
While the entry is displayed, press REDIAL/DEL to delete the
entry. The screen shows D D E E L L E E T T E E ? ?
5.
Press REDIAL/DEL again to delete the entry. D D E E L L E E T T E E D D shows on
screen.
Chain dialing from the directory
Use this feature to make calls that require a sequence of numbers
such as using a calling card for a frequently called long distance
number. You can dial each part of the sequence from a different entry
of the directory. The following example shows how you can use chain
dialing to make a call through a long distance service:
The Number for:
Long distance access number
Authorization code
Frequently called long distance number
1.
Make sure the phone is in TALK mode.
2.
Press MEM and then press 7.
3.
When you hear the access tone, press MEM and then press 8.
4.
At the next access tone, press MEM and then 9.
Tip: Wait for the access tones before pressing the next memory key, or
your call might not go through.
27
Memory Location
7
8
9
Advertisement
Table of Contents
