Installing The Usb Memory - Sanyo POA-USB02 Owner's Manual

Usb memory
Table of Contents

Advertisement

1. Preparation

Installing the USB Memory

Install the optionally available USB memory to the USB terminal on the right side of the projector.
When installing, confirm the direction of the plug not to damage the terminal.
Use optionally available our USB memory (POA-USB02). If you use other product, the projector
may not work properly.
The USB terminal is compatible with USB memory formatted with FAT16 or FAT32.
It is not compatible with other formats. Please note that when you format the USB memory
USB terminal
Caution on Installation and Removal of the USB Memory
Please note following points to install and remove the USB memory.
The USB memory will be blinking when it is installed to the projector or while the projector is
reading out the data. Do not remove the USB memory while it is blinking.
Do not install and remove the USB memory frequently. Remove the USB memory at least 5
seconds after installation. And install at least 5 seconds after removal. While installing or
removing the USB memory, the projector is in switching period for those operation.
Back up your important data
Back up your important USB memory data to the other media (Disk, memory, or tape.) We will
not hold any responsibility for the data loss or data corruption.
Caution on Handling and Storing the USB Memory
- Do not put USB memory or its cap within close reach of children. Swallowing them may cause
suffocation. - If the smoke or questionable odor rise, turn off the peripheral equipment and contact your
dealer. - Do not put water, chemical or oil to the USB memory. It may cause short out or fire. - Do not
put foreign objects or put metal objects to the USB terminal. Static electricity may cause data loss or data
corruption. - Do not remove the USB memory from the computer or the projector while the USB memory
is reading out or writing the data. It may cause data loss or data corruption. - Do not store the USB
memory where high temperature, humid or dusty place or magnetized items are around.
Specifications of USB memory (POA-USB02) *Opetionally available
Interface / Capacity
Operating Voltage
Operating Temperature / Humidity
Dimension(Including the cap)
Compatible OS
6
USB
USB
USB memory*
Blink during access
USB2.0/1.1 / 256MB
DC5V
0-40˚C/0-85%
71.5(Length)/17(Width)/10(Height)mm
Windows XP/Windows2000 Professional
Windows Me
USB lamp*
* The lamp blinks during access
to the USB memory. While
the lamp is blinking, do not
pull out the USB memory. It
may cause data corruption in
the USB memory.

Advertisement

Table of Contents
loading

Table of Contents