Using Speed Dialing; Using Abbreviated Dialing - Sanyo SCP-3100 User Manual

Using Speed Dialing

With this feature, you can dial Speed Dial entries using one key
press for locations 2-9. (See page 66 for storing a Speed Dial
number.)
To use speed dial for voice calls:
From standby mode, press and hold the appropriate key for
approximately two seconds.
– or –
From standby mode, press the appropriate key and
press
The display confirms that the number has been dialed when it
shows "Connecting...".
To use speed dial for 10-4 calls:
From standby mode, press the appropriate key then press
(See "Setting Speed Dialing for 10-4 Entries" on page 102.)
The display confirms that the number has been dialed when it
shows "10-4 calling...".

Using Abbreviated Dialing

Abbreviated Dialing allows you to dial a number by entering 3-6
digits of any number in your Contacts Directory. (See "Setting
Abbreviated Dialing" on page 48.)
1. Dial the last 3-6 digits of a contact's phone number.
2. Press
in your Contacts list, Abbrev. Dial list appears.
3. Select the name you want to call, and then press
to place a call.
Tip:
You can also place a call by pressing
Abbrev. Dial
select
Note:
When
is saved in
disabled), you can display the number by entering its last three to six
digits. (See page 48 for
22
or .
or . If there is more than one matched number
after step 1 above.
Ph. Book Match
Contacts
(regardless of whether
Ph. Book Match
Options
Enable
is set to
Prepend
Prepend
and
(right softkey) and
and your desired number
is enabled or
.)
.
or