Fanimation CCK8002 Instruction Sheet

CCK8002
Close-To-Ceiling Kit
INSTRUCTION SHEET
USE THESE INSTRUCTION IN CONJUNCTION WITH YOUR FANIMATION
FAN OWNERS MANUAL AND IN PLACE OF THE STEPS FOR HOW TO
HANG YOUR CEILING FAN. IF YOU NO LONGER HAVE YOUR MANUAL,
ONE CAN BE DOWNLOADED AT WWW.FANIMATION.COM.
1. To avoid possible shock, be sure electricity is turned off at the fuse box before wiring, and do not operate fan without blades.
2. All wiring and installation procedures must satisfy National Electrical Codes (ANSI/ NFPA 70-1999) and Local Codes. The ceiling fan must
be grounded as a precaution against possible electrical shock. Electrical installation should be made or approved by a licensed electrician.
3. The fan base must be securely mounted and capable of reliably supporting at least 50 lbs. Consult a qualified electrician if in doubt.
4. The fan must be mounted with the fan blades at least 7 feet from the floor to prevent accidental contact with the fan blades.
5. Follow the recommended instructions for the proper method of wiring your ceiling fan. If you do not have adequate electrical knowledge or
experience, have your fan installed by licensed electrician.
6˝ downrod
1. After removing your kit from the packaging, use slight
pressure to push down and remove the screw trim
cover ring from the ceiling canopy assembly. (Figure 1)
2. Separate the ceiling bracket from the ceiling canopy
by loosening the two canopy-to-bracket screws where
the canopy is slotted and completely remove the other
two screws where it is not slotted and set aside for
later. (Figure 2)
3. Twist the ceiling bracket counter-clockwise and lift out
of the ceiling canopy. There is another short canopy
option when it is needed to very close to ceiling.
(Figure 3)

Safety Instructions

4.5˝ downrod
CEILING CANOPY
REMOVE
SCREW
1
Tall close-to-ceiling kit
Figure 1
LOOSEN SCREWS (2)
BUT DO NOT REMOVE
SLOTTED
Figure 2
CEILING BRACKET
CEILING CANOPY
Figure 3
Short close-to-ceiling kit
SCREW TRIM
COVER RING
REMOVE
SCREW
Short Canopy