Control Terminals - Sanyo DSR-C100 Instruction Manual

Control terminals

5
VIDEO OUT terminal (BNC plug)
This terminal is used to connect the camera to a
component such as a monitor or camera control
unit.
6
RESET button
Press the RESET button if an abnormality occurs
with the camera. Settings are not changed
when the camera is reset in this way.
Terminal
1 H (HOLD-UP)
2 GND
3 S (SUSPICION)
4 GND
5 WARNING
6 GND
7 DC 13.8 V
Signal
Alarm switch input signal
Alarm switch and suspicion switch ground 0 V
Suspicion switch input signal
Warning ground
Warning signal output
Power supply ground
Power supply input
WARNING
S
H
GND GND
1 2 3 4 5 6 7
7
Warning indicator
•
The warning indicator lights when the
camera power is turned on.
•
It flashes when there is a hard disk error or if
there is a problem with the backup battery.
2.5 V or higher when alarm switch off/
0.4 V or lower when alarm switch on
2.5 V or higher when suspicion switch off/
0.4 V or lower when suspicion switch on
0 V
3.3 V or higher when warning generated
0 V
13.8 V DC
8
DC13.8V
GND
Input/output voltage
English